dji Zenmuse Z15-BMPCC - Upgrade

©
2014 DJI. All Rights Reserved.
19
Zenmuse Z15-BMPCC
User Manual
PC Assistant Tuning
Upgrade
You can view the latest firmware version information on this page. Upgrade the firmware by
following the steps below:
1. Connect the gimbal to your computer with a Micro-USB cable, and wait until the blue indicator
LED in the Assistant software is blinking.
2. Click “Upgrade”.
3. Wait for the download to nish.
4. Click “Upgrade” again and then click “Conrm”.
5. Power cycle the gimbal (turn it off, then on again) after the upgrade is complete.
Ensure your computer is connected to the internet.
Close any antivirus programs and network rewalls during the upgrade.
Ensure the gimbal is powered on during the upgrade.
Do not disconnect the USB cable during the upgrade.
Info
You can check the Assistant version via Info.
S/N is a 32 digit authorization code for function activations. The authorization code for your unit is
lled in at the time of manufacture. In the future, you may be asked to ll in a new S/N if you require
function upgrades. Fill in the S/N and then click the Write button. If you ll in an invalid S/N more
than 30 times, your gimbal will be locked and you will have to contact our customer support.