dji Zenmuse Z15-BMPCC - Port Description; GCU; Gimbal; Gimbal LED Indicator

24
©
2014 DJI. All Rights Reserved.
Zenmuse Z15-BMPCC
User Manual
Port Description
GCU
ROLL For roll axis control
TILT For tilt axis control
PAN For pan axis control
MODE For Working Mode switch
SHUT Reserved channel
AUX1 For camera aperture control
AUX2 For Gimbal orientation (down or forward) switch in FPV Mode S-Bus Receiver
AUX3 For camera record control PPM Receiver
G7
1. To wireless video transmission module, transmitting AV or HD signals
2. To DJI Lightbridge, transmitting HD and aircraft control signals
XT60 To battery (To GIMBAL if DJI S800 EVO used)
G6 To Gimbal, transmitting motor command
G9 To Gimbal, transmitting video signal
Micro-USB port: PC connection for conguration and rmware upgrades
CAN-Bus port: Use CAN-Bus to connect GCU to the Flight Control System
Gimbal
HDMI-HD/AV Port To camera HDMI port
Motor Command Input Port To GCU G6
9-Pin Cable Port To GCU G9
Gimbal LED Indicator
Description LED Indicator
HD mode, HDMI-HD/AV module transmits normally LED is blinking green.
HD mode, without camera HDMI video input
Green LED is solid on.
HD mode, DJI Lightbridge App video source has been set to “HDMI/AV”
Yellow LED is solid on.
AV mode, HDMI-HD/AV module transmits normally
LED is blinking yellow.
AV mode, without camera HDMI video input
Yellow LED is solid on.
HD video transmission module and gimbal is disconnected
LED is blinking red.
Appendix