Clinician Application Instructions
DonJoy
®
UltraSling
®
PRO AB
A
C
SIZING AND CONFIGURATION:
D
BEFORE USING THE DEVICE, PLEASE READ THE INSTRUCTIONS FOR USE COMPLETELY AND CAREFULLY. CORRECT APPLICATION IS VITAL TO THE PROPER FUNCTIONING OF THE DEVICE.
E
B
Arm envelope is shipped in L/XL configuration. To adjust arm envelope to the S/M size, unbuckle both
quick release buckles (buckles shown on figure A). Fold in arm envelope and adhere hook and loop tabs on
inside of envelope.
ARM SLING SIZE MEASUREMENT
S/M 10.5”-15” (26.7cm-38.1cm)
L/XL 15+” (38.1+cm)
To ensure proper fit, if possible, product should be sized on patient pre-operatively.
Step 1. Open Arm Sling
Release quick-release buckle (i) on cushion and forearm strap (ii) on arm envelope. Unfasten
shoulder ring by releasing quick release buckles (iii) at front of arm envelope. (Fig. A)
Step 2. Apply Waist Belt
Place large cushion under affected area with the 45° angle facing up and wrap the waist belt
around waist, attaching to quick-release buckle at front of cushion. Attach sling to cushion. (Fig B).
Adjust strap and trim as necessary for proper fit.
Step 3. Apply Arm Sling
Place forearm into arm envelope as far back as possible. Secure thumb strap (iv) between thumb
and forefinger at front of sling. Secure forearm strap to sling and cushion. (Fig. C)
Step 4. Apply Shoulder Ring
Place arm through shoulder ring of healthy shoulder. Adjust shoulder ring circumference for
proper fit. (Fig. D) NOTE: The hook and loop closure of shoulder ring should be facing up and
away from patient.
Step 5. Fasten the Shoulder Strap
Fasten shoulder strap to arm envelope by using quick release buckles (iii).
Adjust shoulder strap for proper fit. (Fig. E)
APPLICATION:
BRACE REMOVAL:
Detach quick release buckles, remove forearm strap, thumb strap and waist belt. Slowly remove brace.
Arm Envelope: To size arm envelope, measure elbow crease to base of index finger.
To Next Page
Need help?
General
