Model Woofer Mid Tweeter Nom. Max Sensi- Magnet Inst. Mounting Crossover
power power tivity size depth hole bass driver
US 6.2 16,5 cm / 6,5” US1 28 mm /1,1” 100 W 160 W 91 dB 100 mm / 4” 66 mm / 2,6” 140 mm / 5,51” Separate box
SPEAKER FACTS FOR DLS ULTIMATE US-SERIES
Filter installation and connection of US 6.2
TWEETER LEVEL JUMPER
Select between four different tweeter levels by moving the small
jumper inside the filter box.
-4 dB, -2 dB, 0, +2 dB
Installation of US1 tweeter:
RECESSED MOUNTING 1:
You need a hole with a diameter of 46 mm / 1,88" in the door side, fasten
with four screws.
AB
RECESSED MOUNTING 2:
Sometimes it´s necessary to install the tweeter at places where you cant
use the round flange. The flange (A) is possible to remove from the
tweeter driver (B) by turning it CCW.
If you prefer to install the tweeter with the flange attached to the tweeter
driver, we recommend you to add a string of strong glue on the bottom
side, between flange and chamber, to secure it. This gives you the best
sound reproduction in this installation.
INPUT MIDRANGE TWEETER
+ - + - + -
+
-
Mid
Tweeter
+
-
+
-
Head unit / amp.
-4
-2
0
+2
It is very important that the baffle is stable, but it is just as important
that it is shaped in a way that allows the driver to ”breath”
backwards, otherwise there will be a lack in the drivers bass
reproduction.
Art.no 10-25701
Size 28 mm
Nom. power (RMS) 50 Watts (80 Watts max)
Freq. range 1 kHz-25 kHz
Sensitivity 93 dB
Fs 900 Hz
Overall dimensions 62 mm / 2,44"
Magnet 28 mm / 1,1" neodymium
Mounting depth 25 mm / 1"
Mounting hole 46 mm / 1,81"
Cone material Hand treated fabric
FACTS ABOUT DLS US1 TWEETER
Installation in baffles:
Wrong way
To Previous Page
Loading...
