Chapter 2 13
If you know the velocity of the material you will be measuring you can
manually enter the velocity by doing the following:
Go to the measuring screen.
Touch to enter the Select / Edit mode.
Touch to select the velocity field.
Use the cursors to set the velocity and touch to confirm
or touch to cancel.
Touch the when editing velocity and a screen will
appear with the most commonly used materials and
their velocities. Use the cursor keys to scroll the list and
touch to select or touch to exit and return to
the edit velocity field.
If you do not know the velocity of the material but you know the
material thickness you can set the velocity using the material thickness
value by doing the following:
Measure the material for which you already know the
thickness.
Lift the transducer and touch to enter the Select / Edit
mode.
Touch to select the thickness measurement field.
To Next Page
Loading...