24 Chapter 3
Touch on Gain to change the gain level (signal sensitivity). The
higher the gain the more sensitive the unit will be making it easier to
measure lower thickness values. But excessive gain can also cause
erroneous measurements.
The gain is typically adjusted when changing transducers.
Touch the - keys to adjust the gain
value and touch to save and exit.
Touch to exit without making changes.
Figure 3.16: Adjust gain level
The unit will shutdown automatically if no key is touched or no
measurement is made when you set the auto-off time.
Touch on AutoOff to set the time before the unit automatically
shutdown.
Touch the - keys to set the time and
touch to save and exit.
Touch to exit without making changes.
Figure 3.17: AutoOff time
To Next Page
Loading...