IV
The information included in this manual applies to all QS3 series
ultrasonic wall thickness gauges including models B and DL.
dmq is a registered trademark of demeq S.R.L and its affiliate
companies.
The information contained in this manual is intended to educate users
on the operation of the QS3 gauges. Failure to read and understand
this manual can lead to measurement errors. Decisions based on
measurements and or results that are erroneous can lead to property
damage, personal injury or even death. Demeq S.R.L assumes no
responsibility as a result of the improper use of our instruments.
ASTM E797
The user must be trained in ultrasonic testing procedures and on how
to properly configure the unit for testing. All of the following should
be taken into consideration:
Understand the theory on sound wave propagation.
Select the instrument as well as the transducer that is best
suited for your application.
Know the specific requirements for the test you will be
conducting.
This manual provides all of the information needed to configure and
operate the QS3 gauge. However there are additional factors that can
To Next Page
Loading...