Need help?Do you have a question about the DNA Professional HLC Series and is the answer not in the manual?
General| Brand | DNA Professional |
|---|---|
| Model | HLC Series |
| Category | Mixer |
| Language | English |
Describes the unbalanced Mic input for high impedance signals, suitable for decks, turntables, and keyboards.
Adjusts input sensitivity from -60dB to -20dB or -40dB to 0dB using the pad switch.
Controls the high frequency tone; clockwise rotation increases the level.
Controls the middle frequency tone; clockwise rotation increases the level.
Controls the low frequency tone; clockwise rotation increases the level.
Used to adjust the input signal for effect sound, activating internal digital delay.
Sends signal to left or right main busses; center position sends equal amounts to both.
Red LED indicates signal level at insert return, approximately 5dB below clipping.
Monitors the signal of a channel with the PFL switch ON, muting others.
Adjusts the volume of the signal connected to each channel and the output.
Sends the final confirmed sound to the main amplifier via XLR & 1/4 jack.
Connects external effects for returns and sends.
Connects to a cassette deck for recording the mixed output.
Connects to a cassette deck for playback.
Controls the 24BIT digital effects processor.
Provides 7-band equalization for tone control over frequencies.
Adjusts the signal level for repeat and external effects.
Adjusts the signal level for Mp3 playback.
Master faders for adjusting the volume of the left/right output.
Used for monitoring master and individual channel signals.
Indicates the output condition through master level indication.
Provides +48V Phantom Power on each input Mic socket.
Controls for MP3 player functionality.
Adjusts the volume for auxiliary returns.
Adjusts the volume for CD/Tape returns.
Button to turn the unit on or off. The LED indicates operational status.
Connects the power supply (AC 120V or 230V) to the unit.
Steps for confirming power voltage and setting controls to avoid loud blasts.
Instructions on pushing the power switch and setting master/channel faders.
Guidance on connecting external sources and adjusting gain and tone controls.
Steps for adjusting effect faders, delay, and repeat controls for echo effects.
Illustrates the signal path from input through EQ, faders, effects, and to the power amp.
To Next Page