Putting a Call on Hold and Retrieving a Call from
Hold
To put a call on hold, press the ’Phone’ button until you
hear a single beep which will indicate that the call has
been placed on hold. To bring the call back from hold,
press the ’Phone’ button.
Toggling Between Two Calls
If two calls are in progress (one active and one on hold),
press the ’Phone’ button until you hear a single beep
indicating that the active and hold status of the two calls
have switched. Only one call can be placed on hold at one
time.
Conference Call
When two calls are in progress (one active and one on
hold), press the ’Phone’ button until you hear a double
beep indicating that the two calls have been joined into
one conference call.
Three-Way Calling
To initiate three-way calling, press the ’Voice Recogni-
tion’ button while a call is in progress and make a second
phone call. When the second call is established, press the
’Phone’ button until you hear a double beep indicating
that the two calls have been joined into one conference
call.
Call Termination
To end a call in progress, press the ’Phone’ button. All
calls in progress will be terminated.
Phone Redial
•
Press the ’Phone’ button to begin.
•
After the 9Ready9 prompt, say 9Redial9.
•
The UConnect™ system will call the last number that
was dialed on your cellular phone. This may not be the
last number dialed by your UConnect™ system.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 81
3
To Next Page
Loading...
