TEST ACTION APPLICABILITY
8 Remove all 3 passenger door ajar switches.
With the DRBIIIt,select: Body,Electro/Mech Cluster,Input/Output.
Read the Pas Door Ajar Sw-state.
Disconnect the RKE Module connector while observing the DRBIIIt.
Did the DRBIIIt show, Pas Door Ajar Sw: Open?
All
Yes → Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 9
9 Turn the ignition off.
Disconnect all 3 passenger door ajar switches.
Disconnect the RKE Module connector - If Equipped.
Disconnect the Instrument Cluster connector.
Measure the resistance of the Passenger Door Ajar Circuit in the Passenger Door
Ajar Switch connector.
Is the resistance below 100.0 ohms?
All
Yes → Repair the Passenger Door Ajar/RKE Sense Wire for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1.
10 Turn the Panel Lamps Dimmer to the MID position.
Disconnect the Instrument Cluster Connector.
Measure the resistance between ground and the Courtesy Lamp Driver Circuit.
Is the resistance below 100.0 ohms?
All
Yes → Repair the Courtesy Lamp Driver Circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1.
178
INTERIOR LIGHTING
*COURTESY LAMPS ON AT ALL TIMES — Continued
To Next Page
Loading...
