Symptom:
BODY STYLE MISMATCH
When Monitored and Set Condition:
BODY STYLE MISMATCH
When Monitored: When the ignition is in the run position during Remote Keyless Entry
Module configuration.
Set Condition: Once the body style configuration is complete, the RKE compares its
configuration information with the PCI bus message transmitted by the Powertrain
Control Module pertaining to body style.Amiscomparison will result in setting the trouble
code.
POSSIBLE CAUSES
BODY STYLE MISMATCH
Repair Instructions:
BODY STYLE MISMATCH
With the DRBIII select: 9Theft Alarm9, 9Miscellaneous9, 9Configure Module9 and follow
instructions on the screen.
Perform BODY VERIFICATION TEST - VER 1.
180
POWER DOOR LOCKS/RKE
To Next Page
Loading...
