Dodge 2004 Neon SRT4 - Page 189

TEST ACTION APPLICABILITY
3 NOTE: This test is for vehicles with VTSS. If this vehicle is not equipped
with VTSS, answer YES to the question and continue.
Turn the ignition off.
Disconnect the Remote Keyless Entry module connector.
Remove the driver door inner trim panel.
Disconnect the Cylinder Lock Switch connector.
Measure the resistance between ground and the driver Door Switch Mux circuit
(cavity 10).
Is the resistance below 8000.0 ohms?
All
Yes → Go To 4
No → Replace the Cylinder Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
4 Turn the ignition off.
Disconnect the Door Lock Switch connector.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance between ground and the driver Door Switch Mux circuit
(cavity 10).
Is the resistance below 8000.0 ohms?
All
Yes → Repair the Driver Door Switch Mux circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
182
POWER DOOR LOCKS/RKE
DRIVER DOOR SWITCH SHORTED OR STUCK — Continued