Dodge 2004 Neon SRT4 - Intrusion Sensor Cannot be Disabled (Export Only)

Symptom:
*INTRUSION SENSOR CANNOT BE DISABLED (EXPORT ONLY)
POSSIBLE CAUSES
INTRUSION SENSOR
REMOTE KEYLESS ENTRY MODULE
TEST ACTION APPLICABILITY
1 Disconnect the Dome Lamp/Intrusion Sensor connector.
Measure the voltage between the Intrusion Sensor Signal circuit and ground.
Is the voltage above 10.0 volts?
All
Yes → Replace the Intrusion Sensor.
Perform VTSS VERIFICATION TEST - 1A.
No → Replace the Remote Keyless Entry Module in accordance with the
Service Information.
Perform VTSS VERIFICATION TEST - 1A.
219
VEHICLE THEFT/SECURITY