TEST ACTION APPLICABILITY
3 Open the Passenger Door.
Disconnect the Passenger Door Lock Motor/Ajar Switch connector.
Close all the other passenger doors.
Connect a jumper wire from the Passenger Door Ajar/RKE Sense circuit to ground.
With the DRBIIIt select: THEFT ALARM, VTSS, INPUT/OUTPUT.
With the DRBIIIt, read the PASS DOOR AJAR SW state.
Does the DRBIIIt show: CLOSED?
All
Yes → Replace the Passenger Door Lock Motor/Ajar Switch.
Perform VTSS VERIFICATION TEST - 1A.
No → Repair the DoorAjar Switch Sense circuitfor an openbetween the
door ajar switch and the splice.
Perform VTSS VERIFICATION TEST - 1A.
4 Disconnect the Passenger Door Ajar switch connector.
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for
continuity.
Does the light illuminate?
All
Yes → Go To 5
No → Repair the Left Rear DoorAjar Switch Ground circuit for an open.
Perform VTSS VERIFICATION TEST - 1A.
5 Open the Left Rear Door.
Disconnect the Left Rear Door Ajar Switch connector.
Close all the other Passenger Doors.
Connect a jumper wire from the Passenger Door Ajar/RKE Sense circuit to ground.
With the DRBIIIt select: THEFT ALARM, VTSS, INPUT/OUTPUT.
With the DRBIIIt, read the PASS DOOR AJAR SW state.
Does the DRBIIIt show: CLOSED?
All
Yes → Replace the Left Rear Door Ajar Switch.
Perform VTSS VERIFICATION TEST - 1A.
No → Repair the DoorAjar Switch Sense circuitfor an openbetween the
door ajar switch and the splice.
Perform VTSS VERIFICATION TEST - 1A.
6 Disconnect the Driver Door Ajar switch connector.
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for
continuity.
Does the light illuminate?
All
Yes → Go To 7
No → Repair the Right Rear Door Ajar Switch Ground circuit for an
open.
Perform VTSS VERIFICATION TEST - 1A.
225
VEHICLE THEFT/SECURITY
*OPEN PASSENGER DOOR FAILS TO TRIP ALARM — Continued
To Next Page
Loading...
