TEST ACTION APPLICABILITY
7 Open the Right Rear Door.
Disconnect the Driver Door Ajar Switch connector.
Close all the other Passenger Doors.
Connect a jumper wire from the Passenger Door Ajar/RKE Sense circuit to ground.
With the DRBIIIt select: THEFT ALARM, VTSS, INPUT/OUTPUT.
With the DRBIIIt, read the PASS DOOR AJAR SW state.
Does the DRBIIIt show: CLOSED?
All
Yes → Replace the Right Rear Door Ajar Switch.
Perform VTSS VERIFICATION TEST - 1A.
No → Repair the DoorAjar Switch Sense circuitfor an openbetween the
door ajar switch and the splice.
Perform VTSS VERIFICATION TEST - 1A.
8 Turn the ignition off.
Disconnect the Passenger Door Ajar Switch connector.
Disconnect the RKE Module connector.
Measure the resistance of the Passenger Door Ajar/RKE Sense circuit between the
door ajar switch connector and the RKE module connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Remote Keyless Entry Module.
Perform VTSS VERIFICATION TEST - 1A.
No → Repair the Passenger Door Ajar/RKE Sense circuit for an open.
Perform VTSS VERIFICATION TEST - 1A.
226
VEHICLE THEFT/SECURITY
*OPEN PASSENGER DOOR FAILS TO TRIP ALARM — Continued
To Next Page
Loading...
