EasyManua.ls Logo

Dodge 2004 Neon SRT4 - Page 415

Dodge 2004 Neon SRT4
922 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the TP Sensor harness connector.
Ignition on, engine not running.
Measure the voltage of the (K22) TP Signal circuit in the TP Sensor harness
connector.
Is the voltage above 5.2 volts?
All
Yes Repair the short to battery voltage in the (K22) TP Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
No Go To 4
4 Turn the ignition off.
Disconnect the TP Sensor harness connector.
Connect a jumper wire between the (K22) TP Signal circuit and the (K4) Sensor
ground circuit.
With the DRBIIIt, monitor the TP Sensor voltage.
Ignition on, engine not running.
Is the voltage below 0.5 of a volt?
All
Yes Replace the Throttle Position Sensor.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
No Go To 5
5 Turn the ignition off.
Disconnect the TP Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K167) Sensor ground circuit from the TP Sensor
harness connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
All
Yes Go To 6
No Repair the open in the (K167) Sensor ground circuit.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
6 Turn the ignition off.
Disconnect the TP harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the (K22) TP Signal circuit from the TP harness connector
to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
All
Yes Go To 7
No Repair the open in the (K22) TP Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
79
DRIVEABILITY - NGC
P0123-THROTTLE POSITION SENSOR #1 HIGH Continued

Table of Contents

Other manuals for Dodge 2004 Neon SRT4

Related product manuals