TEST ACTION APPLICABILITY
7 Turn the ignition off.
Replace the Knock Sensor.
Ignition on, engine not running.
With the DRBIIIt, erase DTC.
Attempt to operate the vehicle using the information noted in the Freeze Frame.
With the DRBIIIt, read DTC’s.
Does the DRBIIIt display the DTC that was previously erased?
All
Yes → NOTE: Before continuing, check the PCM harness connector
terminals for corrosion, damage, or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER-5-NGC.
No → Test Complete.
134
DRIVEABILITY - NGC
P0325-KNOCK SENSOR #1 CIRCUIT — Continued
To Next Page
Loading...
