TEST ACTION APPLICABILITY
8 Turn the ignition off.
Install a substitute a Relay in the of the Starter Motor Relay.
Attempt to start the vehicle.
Does the engine crank over?
All
Yes → Replace the Starter Motor Relay.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
No → Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
9 Turn ignition off.
Remove the Starter Relay from the PDC.
Disconnect the Starter Relay Output connector from the Starter Solenoid.
Measure the resistance of the Starter Relay Output circuit between the Relay and the
Solenoid harness connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 10
No → Repair Starter Relay Output circuit for an open.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
10 Turn the ignition off.
Remove the Starter Relay from the PDC.
Using a 12-volt test light connected to ground, probe the Fused B+ circuit at the
Starter Relay terminal.
Does the test light illuminate brightly?
All
Yes → Go To 11
No → Repair the Fused B(+) Circuit for an open or high resistance.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
11 If there are no other possible causes remaining, review repair. All
Repair
Replace the Starter.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
332
STARTING
*NO CRANK CONDITION — Continued
To Next Page
Loading...
