Dodge 2004 Neon SX2 - No Response from Rke

Symptom:
*NO RESPONSE FROM RKE
POSSIBLE CAUSES
OPEN GROUND CIRCUIT
OPEN FUSED B+ CIRCUIT
OPEN FUSED IGNITION SWITCH OUTPUT CIRCUIT
OPEN PCI BUS CIRCUIT
REMOTE KEYLESS ENTRY MODULE
TEST ACTION APPLICABILITY
1 Turn the ignition off.
Turn all lights off.
Disconnect the RKE Module harness connector.
Using a 12-volt test light connected to 12-volts, probe both ground circuits.
Is the test light illuminated for both ground circuits?
All
Yes → Go To 2
No → Repair the ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
2 Turn the ignition off.
Disconnect the RKE Module harness connector.
Using a 12-volt test light connected to ground, probe each Fused B+ circuit.
Is the test light illuminated for each Fused B+ circuit?
All
Yes → Go To 3
No → Check the fuses that feed the Fused B+ circuits for an open. If ok,
repair the Fused B+ circuit that did not illuminate the test light
for an open. Refer to the wiring diagrams in the service informa-
tion.
Perform BODY VERIFICATION TEST - VER 1.
3 Turn the ignition off.
Disconnect the RKE Module harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, probe the Fused Ignition Switch
Output circuit.
Is the test light illuminated?
All
Yes → Go To 4
No → Repair the Fused Ignition Switch Output circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
117
COMMUNICATION