Symptom:
INTERIOR DECKLID RELEASE SWITCH SHORTED OR STUCK
When Monitored and Set Condition:
INTERIOR DECKLID RELEASE SWITCH SHORTED OR STUCK
When Monitored: Whenever the RKE module is connected and the battery is above 10.0
volts..
Set Condition: When a decklid release input is present for more than 8 seconds.
POSSIBLE CAUSES
DTC PRESENT
DECKLID RELEASE SWITCH SHORT TO GROUND.
DECKLID RELEASE RELAY CONTROL CIRCUIT SHORT TO GROUND.
REMOTE KEYLESS ENTRY MODULE - SHORTED
TEST ACTION APPLICABILITY
1 With the DRBIIIt, erase DTCs.
Turn the ignition on.
Operate the decklid release from the interior switch.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display: INTERIOR DECKLID RELEASE SWITCH SHORTED
OR STUCK?
All
Yes → Go To 2
No → The causes for setting this code are not present at thistime. Using
the wiring diagram/schematic as a guide, inspect the wiring and
connectors.
Perform BODY VERIFICATION TEST - VER 1.
2 Disconnect the interior Decklid Release Switch connector.
Turn the ignition on.
Measure the voltage between ground and the Decklid Release Relay Control circuit
in the switch connector
Is the voltage above 10.0 volts?
All
Yes → Replace the Decklid Release Switch.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 3
184
POWER DOOR LOCKS/RKE
To Next Page
Loading...
