Symptom:
*CHECKING PCM POWER AND GROUND CIRCUITS
POSSIBLE CAUSES
(A14) PCM FUSED B+ CIRCUIT
(A41) PCM FUSED IGNITION SWITCH OUTPUT CIRCUIT
(Z12) PCM GROUND CIRCUITS
TEST ACTION APPLICABILITY
1 NOTE: The battery must be fully charged before continuing.
Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Using a 12-volt test light connected to ground, probe the (A14) PCM Fused B+ circuit
in the Pinout Box.
Does the test light illuminate brightly?
All
Yes → Go To 2
No → Repair the (A14) Fused B+ circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
2 Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Turn the ignition on.
Using a 12-volt test light connected to ground, probe the (A41) PCM Fused Ignition
Switch Output circuit in the Pinout Box.
Does the test light illuminate brightly?
All
Yes → Go To 3
No → Repair the (A41) Ignition Switch Output circuit
Perform POWERTRAIN VERIFICATION TEST VER - 1.
3 Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Using a 12-volt test light connected to battery voltage, probe the (Z12) PCM ground
circuits in the Pinout Box.
Does the test light illuminate brightly?
All
Yes → Test Complete.
No → Repair the (Z12) PCM ground circuits.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
292
DRIVEABILITY - NGC
To Next Page
Loading...
