At Each Stop for Fuel
•
Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
•
Check the windshield washer solvent and add if
required. When refilling the washer fluid reservoir,
take some washer fluid and apply it to a cloth or towel
and wipe clean the wiper blades, this will help blade
performance.
Once a Month
•
Check tire pressure and look for unusual wear or
damage.
•
Inspect the battery and clean and tighten the terminals
as required.
•
Check the fluid levels of coolant bottle, brake master
cylinder, and transmission and add as needed.
•
Check all lights and all other electrical items for correct
operation.
At Each Oil Change
•
Change the engine oil filter.
•
Lubricate Drivetrain/Steering/Suspension Grease Fit-
tings (if equipped)
•
Inspect the exhaust system.
•
Inspect the brake hoses.
•
Inspect the CV joints/U— joints (if equipped) and
front suspension components.
•
Check the automatic transmission fluid level.
•
Check the manual transmission fluid level.
•
Check the coolant level, hoses, and clamps.
•
Lubricate Front Drive Shaft Fitting (2500/3500, 4X4).
490 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
To Next Page
Loading...
