2. Position the end of your hand-held transmitter 1-3
inches (3-8 cm) away from the HomeLink buttons.
3. Simultaneously press and hold the HomeLink button
(that you want to train) and the hand-held transmitter
button. Do not release the buttons until Step 4 is
complete.
NOTE:
Some gate operators and garage door openers
may require you to replace this Programming Step 3 with
procedures noted under ⬙Gate Operator/Canadian Pro-
gramming.⬙
4. The EVIC will display “Channel X Training” (where X
is Channel 1, 2, or 3). Release both buttons after the EVIC
displays “Channel X Trained.”
NOTE:
If the EVIC displays “Did Not Train,” repeat
Steps 2–4.
5. Press and hold the just trained HomeLink button and
observe the EVIC display. If the EVIC displays “Channel
X Transmit” (where X is Channel 1, 2, or 3), then
programming is complete, and your device should acti-
vate when the HomeLink button is pressed and released.
NOTE:
To program the remaining two HomeLink but-
tons, begin with ⬙Programming⬙ Step 2. Do not repeat
Step 1.
NOTE:
If your garage door opener fails to respond to
the programmed HomeLink威 Universal Transceiver, and
your garage door opener is manufactured after 1995, it
may have a multiple security code system (rolling code
HomeLink Buttons
106 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
