171
Controls in detail
Operating system with steering wheel buttons*
3
Setting constant headlamp mode*
If you have set constant headlamp mode
and the light switch is at
M, the fol-
lowing light up automatically when the
engine is running:
The parking lamps and low-beam
headlamps
The tail lamps
The license plate lamp
For safety reasons, it is only possible to
change this setting when the vehicle is
stationary. The factory setting is
Con-
stant
in countries in which constant
headlamp mode is mandatory.
Press the æ or ç to select the
Lighting
submenu.
Press the j or k button re-
peatedly until you see the
Hdlmp.
mode
message in the display.
The current setting is highlighted.
Press the æ or ç button to se-
lect whether you wish to operate the
lighting manually or whether you
wish to set constant headlamp
mode.
N54.32-2268-31
i
For safety reasons, it is not possible
to reset the
Hdlmp. mode
function to
the factory setting while the vehicle
is in motion. You will see the follow-
ing message in the display:
Setting
only possible at standstill
nf_BA.book Page 171 Friday, January 25, 2008 3:53 PM
To Next Page
Loading...
