211
Controls in detail
Good visibility
3
Single wipe
Push the combination switch briefly
to the pressure point in the direction
of arrow
1.
The windshield wipers wipe once
without washer fluid.
Wiping with washer fluid
Press the combination switch be-
yond the pressure point in the direc-
tion of arrow
1.
The windshield wiper will wipe with
windshield washer fluid.
Vehicles with headlamp cleaning
system*:
If the low-beam headlamps have
been switched on, a high-pressure
water jet also cleans the headlamps.
For example, if you have selected
speed
II and stop the vehicle,the wip-
ers wipe at intermittent speed until
you pull away again. The wipe intervals
are longer in intermittent mode.
Vehicles with rain sensor*:
You can use speed
I as the universal
speed. The rain sensor adjusts the
wiping frequency according to how
heavy the rain is. If you stop the vehi-
cle, speeds
III and II are automatical-
ly switched down to speed
I.
The original speed of the windshield
wipers is resumed when you drive
faster than 5 mph (8 km/h) again.
i
Wipe with windshield washer fluid even
when it is raining. By doing so you can
prevent smears on the windshield.
nf_BA.book Page 211 Friday, January 25, 2008 3:53 PM
To Next Page
Loading...
