240
Controls in detail
Auxiliary heating/ventilation*
3
To switch the auxiliary heating on:
press button
2.
Indicator lamp
1 lights up briefly.
To switch the auxiliary heating
off:
press button 3.
Indicator lamp
1 lights up briefly.
The auxiliary heating operates for
around a further 2 minutes and then
switches off automatically.
Synchronizing the remote control
Press and hold the ö switch for
more than 10 seconds:
The red indicator lamp in the
ö
switch remains lit until it is released.
Afterward, the red indicator lamp in
the
ö switch flashes. The system
is activated for synchronizing.
Press button 2 on the remote con-
trol.
The indicator lamp in the
ö
switch stops flashing and goes out.
The remote control and the control
panel are synchronized.
Selecting a switch-on time
You can use the operating system to de-
fine up to 3 switch-on times, one of
which can be selected to switch on the
auxiliary heating/ventilation.
i
Change the batteries immediately if
indicator lamp
1 does not light up
briefly each time a button is pressed
(
page 541).
i
If you press button 3 on the remote
control during the first 3 seconds of
synchronization process, only this re-
mote control will be synchronized
with the clock.
Any other remote control units that
were synchronized will be cleared.
nf_BA.book Page 240 Friday, January 25, 2008 3:53 PM
To Next Page
Loading...
