284
Controls in detail
Transporting
3
Mounting lashing points for load
rails*
1 Locking mechanism
To install: slide the lashing eye
through a recess in the load rail close
to the load until locking mechanism
1 in the recess engages.
i
When you pull locking
mechanism
1 out of the recess, the
lashing eye is able to move within the
lashing rail or load rail. Make sure
that locking mechanism
1 is always
engaged in a recess.
Warning G
If the lashing eye is not firmly anchored in
the load rail, the lashing eye may slip or
snap out of the load rail in the event of
sudden braking or an accident.
The load would no longer be secured,
which could result in serious injuries
caused by the load slipping.
For this reason, always check that the
lashing eye is firmly in place whenever
you install it.
nf_BA.book Page 284 Friday, January 25, 2008 3:53 PM
To Next Page
Loading...
