564
Practical hints
Flat tire
5
a Valve core extractor
b Hook
c Knob
d Angle bracket
e Tire valve
Pull knob c out of valve core
extractor
a as far as the stop.
Screw valve core extractor a clock-
wise onto tire valve
e.
Press knob c into the valve core of
tire valve
e, turning it gently as you
do so, until the shaft of valve core
extractor
a engages.
Turn knob c counterclockwise until
the valve core is unscrewed.
Pull knob c out of valve core
extractor
a as far as the stop.
This pulls the valve core into the
valve core extractor and seals it
against the valve core extractor stop.
Hook tire sealant bottle 8 into the
upper vent hole in the wheel using
hook
b.
Press angle bracket d on hose of
tire sealant bottle
8 to the stop on
the flange of valve extractor
a and
clamp it in place.
Make sure that the pressure release
screw on pressure gauge
5 is
closed.
nf_BA.book Page 564 Friday, January 25, 2008 3:53 PM
To Next Page