570
Practical hints
Flat tire
5
After filling with tire sealant
Turn the pressure release screw on
pressure gauge
5 counterclock-
wise and bleed the system.
Turn the key to position 0 in the igni-
tion lock (
page 111).
Pull the electric air pump connector
out of the 12 V socket.
Store the electric air pump, tire seal-
ant bottle
8 with valve core
extractor
c and, if used, the warn-
ing triangle and hazard warning
lamps inside the vehicle.
Unscrew and remove angle bracket
2 from valve 7 on tire sealant bot-
tle
8 and screw the valve cap onto
the valve.
Pull away immediately.
This enables the tire sealant to dis-
tribute inside the tire and create a
more effective seal.
Stop after about 3 minutes and
check the tire pressure using the
electric air pump, for example.
Warning G
Do not exceed the maximum speed of
50 mph (80 km/h).
The "max. 50 mph (80 km/h)" sticker
must be affixed within the driver's field of
vision.
The vehicle’s handling characteristics
may be affected.
i
You must connect the angle bracket
on hose
3 of the electric air pump
directly to the tire valve on the tire.
nf_BA.book Page 570 Friday, January 25, 2008 3:53 PM
To Next Page
Loading...
