VOICE RECOGNITION
• The Voice Recognition (VR) system allows you to control your AM, FM radio, satellite
radio, disc player, and a memo recorder. When you press the VR button
, you will
hear a beep. The beep is your signal to give a command. If you do not say a command
within a few seconds, the system will present you with a list of options. If you ever
wish to interrupt the system while it lists options, press the VR button
,listenfor
the BEEP, and say your command.
• Please refer to uconnect™ tunes in the uconnect™ User's Manual on the DVD for
further details.
Changing The Volume
• Start a dialogue by pressing the VR button , then say a command (e.g., “tutorial”).
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Voice Recognition system is speaking. Please note the volume setting for
Voice Recognition is different than the audio system.
WARNING!
Any voice commanded system should be used only in safe driving conditions and all
attention should be kept on the roadway ahead. Failure to do so may result in an
accident causing serious injury or death.
NOTE: To access the tutorial, press the VR button
. After the BEEP, say “tutorial”.
Press any hard-key or touch the display to cancel the tutorial.
ELECTRONICS
44
To Next Page
Loading...
