EasyManua.ls Logo

Dodge 2013 Challenger SRT8 - Jump-Starting

Dodge 2013 Challenger SRT8
140 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
JUMP-STARTING
If your vehicle has a discharged battery it
can be jumpstarted using a set of jumper
cables and a battery in another vehicle or
by using a portable battery booster pack.
Jump-starting can be dangerous if done
improperly so please follow the proce-
dures in this section carefully.
NOTE:
When using a portable battery booster pack
follow the manufacturers operating instruc-
tions and precautions.
Preparations for Jump-Start
The battery is stored under an access cover in the trunk. Remote battery posts are
located on the right side of the engine compartment for jump-starting.
NOTE:
The remote battery posts are viewed by standing on the right side of the vehicle looking over
the fender.
Set the parking brake, shift the automatic transmission into PARK and turn the ignition to
LOCK.
Turn off the heater, radio, and all unnecessary electrical accessories.
If using another vehicle to jump-start the battery, park the vehicle within the jumper
cables reach, set the parking brake and make sure the ignition is OFF.
Jump-Starting Procedure
Connect the positive (+) end of the jumper cable to the remote positive (+) post of the
discharged vehicle.
Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the
booster battery.
Connect the negative end (-) of the jumper cable to the negative (-) post of the booster
battery.
Connect the opposite end of the negative (-) jumper cable to the remote negative (-) post
of the vehicle with the discharged battery.
Start the engine in the vehicle that has the booster battery, let the engine idle a few
minutes, and then start the engine in the vehicle with the discharged battery.
WHAT TO DO IN EMERGENCIES
97

Table of Contents

Related product manuals