FRONT SEATS
Power Seat
• The power seat switch controls forward/
back, up/down, and tilt adjustment.
• The recline switch, located on the out-
board side of the seat, controls seatback
adjustment.
Power Lumbar
• Push the switch forward to increase the
lumbar support. Push the switch rearward
to decrease the lumbar support.
Manual Seat Adjustment
Forward/Rearward
• Lift up on the adjusting bar located at the
front of the seat near the floor and release
at the desired position. Then, using body
pressure, move forward and backward on
the seat to be sure that the seat adjusters
have latched.
Recliner
• Lift the recliner lever located on the out-
board side of the seat, lean back and re-
lease at the desired position.
Memory Seat
• The memory seat feature allows you to
save two different driver seating posi-
tions, driver's outside mirror, adjustable
brake and accelerator pedals, and radio
station preset settings. The memory seat
buttons are located on the driver's door
panel.
• Adjust all memory profile settings, press
the SET button then press 1 or 2 within five
seconds.
• To program a Key Fob to the memory po-
sition, press and release the LOCK button
within 10 seconds on the Key Fob to be programmed.
• Place the ignition switch in the ON position, select Remote Linked to Memory in the
Electronic Vehicle Information Center (EVIC) and enter Yes.
• Press 1 or 2 to recall the saved positions, or press UNLOCK on the programmed Key Fob.
GETTING STARTED
16
To Next Page
Loading...
