ENGINE STARTING/STOPPING
Starting
1. Fully apply the parking brake.
2. Press the clutch pedal to the floor .
3. Place the shift lever in NEUTRAL.
4. Press the red ENGINE START/STOP
button located on the instrument panel.
Release the button when the engine
starts.
NOTE:
The engine will not start unless the clutch
pedal is pressed to the floor .
Stopping
1. Bring the vehicle to a complete stop.
2. Fully apply the parking brake.
3. Press the clutch pedal to the floor .
4. Place the shift lever in NEUTRAL/1st Gear .
5. Press the ENGINE STAR T/STOP button once. The ignition switch will return to the OFF
position.
THEFT ALARM
To Arm:
Follow these steps to arm the V ehicle Security Alarm:
• Press LOCK on the interior power door lock switch with the driver and/or passenger door
open.
• Press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
NOTE:
Using the key to open the liftgate while the V ehicle Security Alarm is armed will not
trigger the theft alarm.
To Disarm:
The V ehicle Security Alarm can be disarmed using any of the following methods:
• Press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter.
• Cycle the vehicle ignition system out of the OFF position.
GETTING STARTED
9
To Next Page
Loading...
