Engine Starting/Stopping — Automatic Transmission
Starting
• Place the shift lever in PARK or NEU-
TRAL.
• Press and hold the brake pedal, then
push the ENGINE ST AR T/STOP button
once. If the engine fails to start, the
starter will disengage automatically after
10 seconds.
• To stop the cranking of the engine prior
to the engine starting, push the button
again.
Stopping
1. Place the shift lever in P ARK.
2. Push the ENGINE ST AR T/STOP button
once. The ignition switch will return to
the OFF position.
If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two
seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off.
NOTE:
If the ignition switch is left in the ACC or RUN (engine not running) position and the
transmission is in PARK, the system will automatically time out after 30 minutes of
inactivity and the ignition will switch to the OFF position.
Engine Starting/Stopping — Manual Transmission
Starting
• Push and hold the clutch pedal while pushing and holding the ENGINE ST ART/STOP
button. Release the button when the engine starts. If the engine fails to start within 15
seconds, release the button, wait 10 to 15 seconds, then repeat.
• To stop the cranking of the engine prior to the engine starting, release the button.
1 – Start/Stop Button
GETTING STARTED
19
To Next Page
Loading...
