Near
Changing the FCW status to the “Near” setting, allows the system to warn you of a
potential frontal collision when you are much closer.
This setting provides less reaction time than the “Far” setting, which allows for a more
dynamic driving experience.
More dynamic or aggressive drivers that want to avoid frequent warnings may prefer this
setting.
Refer to the Owner's Manual on the DVD for further details.
WARNING!
Forward Collision W arning (FCW) is not intended to avoid a collision on its own, nor can
FCW detect every type of potential collision. The driver has the responsibility to avoid
a collision by controlling the vehicle via braking and steering. Failure to follow this
warning could lead to serious injury or death.
PARKSENSE REAR PARK ASSIST
The ParkSense Park Assist system provides visual and audible indications of the distance
between the rear bumper and a detected obstacle when backing up, e.g. during a parking
maneuver.
ParkSense can be enabled and disabled with the ParkSense switch, located on the switch
panel below the Uconnect display.
NOTE:
ParkSense will retain the last system state (enabled or disabled) from the last ignition
cycle when the ignition is changed to the ON/RUN position.
ParkSense can be active only when the gear selector is in REVERSE. If ParkSense is
enabled at this gear selector position, the system will remain active until the vehicle speed
is increased to approximately 7 mph (11 km/h) or above. The system will become active
again if the vehicle speed is decreased to speeds less than approximately 6 mph (9 km/h).
The four ParkSense sensors, located in the rear fascia/bumper , monitor the area behind
the vehicle that is within the sensors’ field of view .
OPERATING YOUR VEHICLE
56
To Next Page
Loading...
