NOTE: The plastic plate will prevent the road wheel from
being scratched when sliding it under the vehicle.
11.
Insert the two long tubes on the plastic protective plate
in the lug holes of the road wheel. Push the end of the
winch’s cable, spring, steel sleeve and stamped cone
shape wheel plate though the road wheel and protective
plate.
12. Slide the road wheel on the ground using the protec-
tive plate until it is directly under the winch and
between the rear bumper and exhaust system heat
shields. Raise the tire by turn the lug wrench on the
winch extension clockwise until it clicks/ratchets
three times to make sure the cable is tight.
“Beauty Side”
Installing Winch
614 WHAT TO DO IN EMERGENCIES
To Next Page
Loading...
