Lock Or Unlock The Liftgate:
• With a valid Keyless Enter-N-Go Key Fob within 3 feet (1 meter) of the liftgate, push the
electronic liftgate lock/unlock pad located to the left of the liftgate handle to unlock the
liftgate. Push the button a second time to lock the liftgate.
NOTE:
Refer to your Owner's Manual on the DVD
for further information.
ENGINE STARTING/STOPPING
Starting
• With a valid Keyless Enter -N-Go Key Fob
inside the vehicle.
•
Place the shift lever in PARK or NEUTRAL.
•
While pushing the brake pedal, push the
ENGINE ST ART/STOP button once. If the
engine fails to start, the starter will disen-
gage automatically after 10 seconds.
•
To stop the cranking of the engine prior to
the engine starting, push the button again.
NOTE:
In case the ignition switch does not change
with the push of a button, the RKE trans-
mitter (Key Fob) may have a low or dead
battery. In this situation, a back up method
can be used to operate the ignition switch. Put the nose side of the Key Fob against the
ENGINE STAR T/STOP button and push to operate the ignition switch.
1 — Electronic Liftgate Lock/Unlock Pad
Engine Start/Stop Button
GETTING STARTED
12
To Next Page
Loading...
