Dodge B-I-B 1948 - FRONT END, FRONT AXLE AND STEERING GEAR LUBRICATION; FRONT AXLE AND SUSPENSION LUBE; STEERING GEAR AND WHEEL BEARING LUBE

1.&
3. &
FRONT END, FRONT AXLE AND STEERING
GEAR LUBRICATTON
EVERY 1,000 MILES
2. FRONT
SPRING
BOLT-l fitting each side .
Semi-fluid
lubricant.
4. KING PIN BUSHINGS-2 fittings each side.
Semi-fluid
lubricant .
Chassis
Chassis
5. & 6. TIE ROD BAll JOINT-l fitting each end of tie rod. Semi-fluid Chassis
lubricant.
7. & 8. FRONT SPRING SHACKlE-2 fittings each side . Semi-fluid Chassis
lubricant.
9. & 10 . DRAG LINK BAll JOINT -1 fitting each end of drag link. Semi-fluid
Chassis lubricant .
EVERY 10,000 MILES
11. STEERING GEAR-Remove filler plug and check level of lubricant. If
lubricant level is below filler plug hole, replenish with SAE 90 low cold
test Fluid Gear lubricant.
EVERY 15,000 MILES
12 . & 13. FRONT WHEEL BEARINGS-Remove hub and bearings, clean and re-
pack with Short Fiber Wheel Bearing Grease.
19