Dodge B-I-B 1948 - LUBRICATION OF TRANSMISSION AND NEAR-BY CONTROLS; TRANSMISSION AND CLUTCH RELEASE LUBE

LUBRICA nON OF TRANSMISSION AND
NEAR-BY CONTROLS
EVERY 1,000 MILES
1. BRAKE PEDAL-l fitting. Semi-fluid Chassis lubricant.
2.
BRAKE PEDAL CLEVIS PINS, ROD CONNECTIONS AND WICK IN CLUTCH
RelEASE . FORK BEARING-Engine Oil.
3. HAND BRAKE CONNECTIONS-Apply Engine Oil to clevis pins and rod
connections.
Also apply a few drops of Engine Oil to hand brake lever pivot.
4. PROPELLER SHAFT SPLINE-l fitting. Semi-fluid Chassis Lubricant.
5.
UNIVERSAL JOINT-l fitting. Semi-fluid Chassis lubricant.
EVERY 15,000 MILES
6. TRANSMISSION-(Capacity 3 Y2 pts.) Drain and refill with Fluid Gear
Lubricant, using the proper SAE grades for atmospheric temperatures os
follows:
If it is anticipated that the atmospheric temperature will be:
Above
+ 32° F .. • ••..••••••••••••••••. Use SAE 140
As low as - 10° F .•.•..•....•••••••••.• Use SAE 90
Below - 10° F .••••...•.......••...•... Use SAE 90 blended with 20%
of No. lOW Engine Oil or use
SAE 80 Gear lubricant.
21