EasyManua.ls Logo

Dodge Challenger 2013 SRT8 - Programmable Features

Dodge Challenger 2013 SRT8
140 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PROGRAMMABLE FE ATURES
Electronic Vehicle Information Center (EVIC) If Equipped
The EVIC can be used to program the following Personal Settings. Press and release the
MENU
button until Personal Settings displays, then press the UP or DOWN but-
tons to scroll through the settings. Press the SELECT
button to change the setting.
Language Hill Start Assist (HSA)
Unlock Doors Automatically on Exit
Turn Headlights On with Remote Key Unlock
Remote Key Unlock Delay Power Off to Accessories Until Exit
Remote Start Comfort Sys. Turn-by-Turn Navigation
Sound Horn with Remote Key Lock Display ECO Mode
Flash Lights with Remote Key Lock Keyless Enter-N-Go™
Headlamps On with Wipers
(Available with Auto Headlamps Only)
Enable/Disable The Rear Park Assist
System
Delay Turning Headlights Off Display Units of Measure In
Lock Doors Automatically Park Assist Sound And Display
Key Fob Programmable Feat ures
The following features may also be programmed by using the Key Fob transmitter or the
ignition switch and driver's door lock switch.
NOTE:
Pressing the LOCK button while you are inside the vehicle will activate the Vehicle Security
Alarm. Opening a door with the Vehicle Security Alarm activated will cause the alarm to
sound. Press the UNLOCK button to deactivate the Vehicle Security Alarm.
Unlock On First Press
To unlock either the driver's side, or all doors, on the first press of the UNLOCK button:
Press and hold the LOCK button for at least four seconds, but no longer than 10 sec-
onds. Then, press and hold the UNLOCK button while still holding the LOCK button.
Release both buttons at the same time.
Auto Unlock Doors On Exit
To have all of the vehicle doors unlock when any door is opened:
Enter your vehicle and close all the doors, and fasten your seat belt.
Cycle the ignition switch between the LOCK and ON position four times, ending in the
LOCK position (do not start the engine).
Press the power door UNLOCK switch to unlock the doors. A single chime will indicate
that programming is complete.
ELECTRONICS
68

Table of Contents

Related product manuals