Engine Starting/Stopping — Automatic Transmission
Starting
• Place the gear selector in PARK or NEU-
TRAL.
• Press and hold the brake pedal, then
push the ENGINE START/STOP button
once. If the engine fails to start, the
starter will disengage automatically after
10 seconds.
• To stop the cranking of the engine prior
to the engine starting, push the button
again.
Stopping
1. Place the gear selector in P ARK.
2. Push the ENGINE START/STOP button
once. The ignition switch will return to
the OFF position.
If the gear selector is not in PARK, the ENGINE START/STOP button must be held for two
seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off.
NOTE:
If the ignition switch is left in the ACC or RUN (engine not running) position and the
transmission is in P ARK, the system will automatically time out after 30 minutes of
inactivity and the ignition will switch to the OFF position.
Engine Starting/Stopping — Manual Transmission
Starting
• Push and hold the clutch pedal while pushing and holding the ENGINE ST ART/STOP
button. Release the button when the engine starts. If the engine fails to start within
15 seconds, release the button, wait 10 to 15 seconds, then repeat.
• To stop the cranking of the engine prior to the engine starting, release the button.
Stopping
• With the vehicle stopped, place the gear selector in NEUTRAL.
• Push the ENGINE START/STOP button once. The ignition switch will return to the OFF
position.
Start/Stop Button
GETTING STARTED
18
To Next Page
Loading...
