Automatic High Beam —
If Equipped
This system automatically controls the operation
of the headlamp high beams as oncoming vehicles
approach.
• The Automatic High Beam Headlamp Control
can be turned on or off using the Uconnect
System.
• Push the turn signal lever away from you.
•
With the headlight switch in the “AUTO” posi-
tion, the high beams are controlled automatically.
• Pull the turn signal lever toward you to manu-
ally deactivate the system.
• To improve system recognition of crossing traf-
fic, and to limit use in a residential area, the
vehicle must be moving at a speed greater than
20 mph (32 km/h) before the Automatic High
Beam Module (AHBM) begins requesting high
beam activation.
NOTE:
If the windshield or Automatic High Beam Head-
lamp Control mirror is replaced, the mirror must
be re-aimed to ensure proper performance. See an
local authorized dealer.
For further information, and applicable warnings
and cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca
(Canadian Residents).
Adaptive Cruise Control (ACC) —
If Equipped
If your vehicle is equipped with Adaptive Cruise
Control, the controls operate exactly the same as
the standard cruise control, with one difference.
You can set a specified distance you would like to
maintain between you and the vehicle in front of
you.
• If the ACC sensor detects a vehicle ahead, ACC
will apply limited braking or acceleration auto-
matically to maintain a preset following dis-
tance while matching the speed of the vehicle
ahead.
NOTE:
Your vehicle will not exceed the cruise speed you
have set.
LIGHTS SPEED CONTROL
To Next Page
Loading...
