Dodge Challenger 2019 - Chassis; Fluids and Lubricants - Srt; Engine

Chassis
Component Fluid, Lubricant, or Genuine Part
8-Speed Automatic Transmission Use only Mopar ZF 8&9 Speed ATF Automatic Transmission Fluid, or equivalent. Failure to use the
correct fluid may affect the function or performance of your transmission.
Manual Transmission – If Equipped We recommend you use Mopar ATF+4 Automatic Transmission Fluid.
Brake Master Cylinder W e recommend you use Mopar DOT 3, SAE J1703. If DOT 3 brake fluid is not available, then DOT
4 is acceptable.
Front Axle W e recommend you use Mopar Synthetic Gear Lubricant SAE 75W90 (API GL-5).
Rear Axle – 3.6L/5.7L Engine With Automatic
Transmission
W e recommend you use Mopar OD Synthetic Gear Lubricant SAE 75W85 (API GL-5).
Rear Axle – 6.4 Engine or 5.7 With Manual
Transmission
W e recommend you use Mopar LSD Synthetic Gear Lubricant SAE 75W85 (API GL-5).
Transfer Case – A WD (If Equipped) We recommend you use Mopar Transfer Case Lubricant for BorgW arner 44–40.
FLUIDS AND LUBRICANTS — SRT
Engine
Component Fluid, Lubricant, or Genuine Part
Engine/Intercooler Coolant W e recommend you use Mopar Antifreeze/Coolant 10 Y ear/150,000 Mile (240,000 km) Formula OAT
coolant conforming to MS.90032.
Engine Oil For best performance and maximum protection under all types of operating conditions, the manufac-
turer only recommends full synthetic engine oils.
The manufacturer recommends the use of Pennzoil Ultra Platinum 0W -40 or equivalent Mopar engine
oil meeting the requirements of FCA Material Standard MS-12633 for use in all operating tempera-
tures.
TECHNICAL SPECIFICATIONS
196