Dodge Challenger 2019 - Rear Head Restraints; Vehicles Without Passenger Seating Installed

To remove the head restraint, remove the seat
belt from the seat belt loop. Raise the head
restraint as far as it can go. Then, push the
adjustment button and the release button at the
base of each post while pulling the head re-
straint up. To reinstall the head restraint, put
the head restraint posts into the holes while
pushing the adjustment button and release but-
ton. Then, adjust it to the appropriate height.
NOTE:
It may be necessary to recline the front seat
before removing the head restraint to provide
enough clearance from the roof.
WARNING!
• A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head re-
straints in a location outside the occupant
compartment.
• ALL the head restraints MUST be rein-
stalled in the vehicle to properly protect
the occupants. Follow the re-installation
WARNING!
instructions above prior to operating the
vehicle or occupying a seat.
• Do not place items over the top of the
Reactive Head Restraint, such as coats,
seat covers or portable DVD players. These
items may interfere with the operation of
the Reactive Head Restraint in the event of
a collision and could result in serious in-
jury or death.
Rear Head Restraints
The rear outboard head restraints are non-
adjustable and are designed to reduce the risk
of injury by restricting head movement in the
event of a rear impact.
Vehicles Without Passenger Seating
Installed
All passenger occupants within the vehicle
must be in a seat equipped with a Seat Belt
System and Head Restraint for the safety of the
passenger. If the passenger and/or rear seats
have been removed, do not ride in those areas.
This vehicle has been designed to maximize
total performance. In doing so, the deletion of
passenger seats and/or rear seat may affect the
NVH (Noise, Vibration, and Harshness) charac-
teristics. As a result, the interior (driver cockpit)
Noise, Vibration, and Harshness (NVH) will be
louder overall.
WARNING!
• If the passenger and/or rear seats have
been removed, do not ride in those areas.
In a collision, people riding in these areas
are more likely to be seriously injured or
killed.
• If this vehicle was not factory equipped
with a passenger seat, NEVER attempt to
install a passenger seat because the safety
systems, including the air bags and seat-
belt, may not properly protect you.
• It is dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision,
people riding in this area are more likely to
be seriously injured or killed.
• Only ride in available seating positions
equipped with seat belt systems. Always
properly wear your seat belt. Failure to do
GETTING TO KNOW YOUR VEHICLE
24