58 MULTIMEDIA
6. Hold the brake firmly and make sure the
vehicle is in DRIVE.
7. While holding the brake, rapidly
(within 0.25 seconds) apply and hold the
accelerator pedal to wide open throttle.
The engine speed will hold at the RPM that was
set in the “Launch RPM Set-Up” screen.
NOTE:
Messages will appear in the instrument cluster to
inform the driver if one or more of the above condi-
tions have not been met.
8. When conditions 4 through 7 have been met,
the instrument cluster display will read
“Launch Ready Release Brake”.
9. Keep the vehicle pointed straight.
Launch Control will be active until the vehicle
reaches 62 mph (100 km/h), at which point the
Electronic Stability Control (ESC) system returns to
its current ESC mode.
Launch Control will abort before launch
completion, and will display “Launch Aborted” in
the cluster under any the following conditions:
The accelerator pedal is released during launch.
The ESC system detects that the vehicle is no
longer moving in a straight line.
The ESC OFF button is pushed to change the
system to another mode.
NOTE:
After Launch Control has been aborted, ESC will
return to its current ESC mode.
Pushing the LAUNCH button, or pressing the
Activate Launch Control button on the touch-
screen, will immediately activate Launch
Control and will not allow you to adjust the RPM.
MANUAL TRANSMISSION — IF EQUIPPED
Vehicles with a manual transmission have an
adjustable Launch RPM controlled through the
Uconnect system.
Launch Control is only available when the following
procedure is followed:
1. Push the Drive Modes button, then push the
Race Options button, then press the Launch
Control button on the left side of the
touchscreen to begin the process
NOTE:
Pushing the SRT button on the center stack or
pressing the Apps button on the touchscreen are
two other options to access Launch Mode
features.
22_LALD_S_SU_EN_USC_t.book Page 58
To Next Page
Loading...
