MULTIMEDIA 59
2. Slide the RPM slider bar on the touchscreen.
This screen will allow you to adjust your
Launch RPM’s for optimum launch/traction. If
Launch Control is already activated, you will
need to deactivate it to adjust the slider.
3. Press “Activate Launch Control”.
4. Make sure the vehicle is not moving.
5. Make sure the steering wheel is pointing
straight.
6. Fully press the clutch pedal and make sure the
vehicle is in FIRST gear.
7. While holding the clutch pressed, rapidly apply
and hold the accelerator pedal to wide open
throttle. The engine speed will hold at the
pre-selected Launch RPM. The engine speed
will hold at the RPM that was set in the
“Launch RPM Set-Up” screen.
NOTE:
Messages will appear in the instrument cluster to
inform the driver if one or more of the above condi-
tions have not been met.
8. When conditions 4 through 7 have been met,
the instrument cluster display will read
“Launch Ready Release Clutch”. Release the
clutch quickly and continue to hold the throttle
to execute launch. Refer to “Manual
Transmission – If Equipped” in “Starting And
Operating” in the Owner’s Manual for further
information.
Release the clutch and continue to hold
wide open throttle to launch.
9. Keep the vehicle pointed straight.
Launch Control will be active until the vehicle
reaches 62 mph (100 km/h), at which point the
ESC system returns to its current ESC mode.
Launch Control will abort before launch
completion, display “Launch Aborted” in the
cluster and return to ESC Full On under any the
following conditions:
The brake is applied during launch.
The ESC system detects that the vehicle is no
longer moving in a straight line.
The ESC OFF button is pushed to change the
ESC system to another mode.
NOTE:
After Control Mode has been aborted, ESC will
return to its current ESC mode.
Pushing the LAUNCH button, or pressing the
Activate Launch Control button on the touch-
screen, will immediately activate Launch
Control and will not allow you to adjust the RPM.
CAUTION!
Do not attempt to shift when the drive wheels
are spinning and do not have traction. Damage
to the transmission may occur.
5
22_LALD_S_SU_EN_USC_t.book Page 59
To Next Page
Loading...
