To Unlatch The Trunk
Push the trunk button on the key fob two times within
five seconds to unlatch the trunk.
Using The Panic Feature
To turn the Panic feature on or off, push the Panic but-
ton on the key fob. When the Panic feature is activated,
the turn signals will flash, the horn will pulse on and off,
and the interior lights will turn on.
The Panic feature will stay on for three minutes unless
you turn it off by either pushing the Panic button a sec-
ond time or drive the vehicle at a speed of 15 mph
(24 km/h) or greater.
NOTE:
•
The interior lights will turn off if you place the igni-
tion in the ACC or ON/RUN position while the Panic
feature is activated. However, the exterior lights and
horn will remain on.
•
You may need to be less than 35 ft (11 m) from the
vehicle when using the key fob to turn off the Panic
feature due to the radio frequency noises emitted by
the system.
Key Left Vehicle Feature
If a valid key fob is no longer detected inside the vehicle
while the vehicle’s ignition system is in the ON/RUN or
START position, the message “Key Fob Has Left The
Vehicle” will be shown in the instrument cluster display
along with an interior chime. An exterior audible and
visual alert will also be activated to warn the driver.
The vehicle’s horn will rapidly chirp three times along
with a single flash of the vehicle’s exterior lights.
NOTE:
•
The doors have to be open and then closed in order
for the vehicle to detect a key fob; the Key Left
Vehicle feature will not activate until all of the doors
are closed.
•
These alerts will not be activated in situations where
the vehicle’s engine is left running with the key fob
inside.
Replacing The Battery In The Key Fob
The recommended replacement battery is one
CR2032 battery.
NOTE:
•
Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin
battery dimensions.
•
Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
for further information.
•
Do not touch the battery terminals that are on the
back housing or the printed circuit board.
1. Remove the emergency key (2) by sliding the emer-
gency key release (1) on the back of the key fob and
pulling the emergency key out with your other hand.
2. Separate the key fob halves using a flat-head screw-
driver or a coin, and gently pry the two halves of the
key fob apart. Make sure not to damage the seal
during removal.
Emergency Key Removal
1 — Emergency Key Release Button
2 — Emergency Key
Emergency Key Removal
GETTING TO KNOW YOUR VEHICLE 13
2
5548538-23_LA_OM_EN_USC_t_E2.pdf 13 4/7/2023 2:38:35 PM
To Next Page
Loading...
