NOTE:
Separating the case can also be done with a flat-
head screwdriver.
3. Remove the back cover to access and replace the
battery. When replacing the battery, match the (+)
sign on the battery to the (+) sign on the inside of
the battery clip, located on the back cover. Avoid
touching the new battery with your fingers. Skin oils
may cause battery deterioration. If you touch a bat-
tery, clean it with rubbing alcohol.
4. To assemble the key fob case, snap the two halves
together.
WARNING!
•
The integrated key fob contains a coin cell battery.
Do not ingest the battery; there is a chemical burn
hazard. If the coin cell battery is swallowed, it can
cause severe internal burns in just two hours and
can lead to death.
•
If you think a battery may have been swallowed or
placed inside any part of the body, seek immediate
medical attention.
(Continued)
WARNING!
•
Keep new and used batteries away from children.
If the battery compartment does not close
securely, stop using the product and keep it away
from children.
Programming And Requesting
Additional Key Fobs
Programming the key fob may be performed by an
authorized dealer.
NOTE:
•
Once a key fob is programmed to a vehicle, it cannot
be repurposed and reprogrammed to another
vehicle.
•
Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the
vehicle.
WARNING!
•
Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle
unattended.
•
For vehicles equipped with Keyless Enter ‘n Go™
Ignition, always remember to place the ignition in
the OFF position when exiting the vehicle.
Separating Case With A Coin
Separating Case With A Flat-Head Screwdriver
Key Fob Battery Replacement
14 GETTING TO KNOW YOUR VEHICLE
5548538-23_LA_OM_EN_USC_t_E2.pdf 14 4/7/2023 2:38:35 PM
To Next Page
Loading...
