Automatic Temperature Control (ATC) — If Equipped
The climate controls will be automatically adjusted to
the optimal temperature and mode settings depending
on the outside ambient temperature. This will occur
until the ignition is placed in the ON/RUN position
where the climate controls will resume their previous
settings.
Manual Temperature Control (MTC) — If Equipped
•
In ambient temperatures at 40°F (4.5°C) or below,
the climate settings will default to maximum heat,
with fresh air entering the cabin. If the front defrost
timer expires, the vehicle will enter Mix Mode.
•
In ambient temperatures from 40°F (4.5°C) to
78°F (26°C), the climate settings will be based on
the last settings selected by the driver.
•
In ambient temperatures at 78°F (26°C) or above,
the climate settings will default to MAX A/C, Bi-Level
Mode, with Recirculation on.
For more information on ATC, MTC, and climate control
settings, see
page 42.
NOTE:
These features will stay on through the duration of
Remote Start until the ignition is placed in the ON/RUN
position. The climate control settings will change if
manually adjusted by the driver while the vehicle is in
Remote Start mode, and exit automatic override. This
includes the OFF button on the climate controls, which
will turn the system off.
REMOTE START WINDSHIELD
WIPER DE-ICER ACTIVATION —
IF EQUIPPED
When Remote Start is active and the outside ambient
temperature is less than 33°F (0.6°C), the Windshield
Wiper De-Icer will activate. Exiting Remote Start will
resume its previous operation. If the Windshield Wiper
De-Icer was active, the timer and operation will
continue.
REMOTE START CANCEL MESSAGE
— IF EQUIPPED
One of the following messages will display in the instru-
ment cluster display if the vehicle fails to remote start
or exits Remote Start prematurely:
•
Remote Start Canceled — Door Open
•
Remote Start Canceled — Hood Open
•
Remote Start Canceled — Fuel Low
•
Remote Start Canceled — Trunk Open
•
Remote Start Disabled — Start Vehicle To Reset
The message will stay active until the ignition is placed
in the ON/RUN position.
VEHICLE SECURITY SYSTEM —
IF EQUIPPED
The Vehicle Security system monitors the vehicle doors
for unauthorized entry and the Keyless Enter ‘n Go™
Ignition for unauthorized operation. While the Vehicle
Security system is armed, interior switches for door
locks and trunk release are disabled.
If something triggers the alarm, the Vehicle Security
system will provide the following audible and visible
signals:
•
The horn will pulse
•
The turn signals will flash
•
The Vehicle Security Light in the instrument cluster
will flash
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security system:
1. Make sure the vehicle’s ignition is placed in the OFF
position.
2. Perform one of the following methods to lock the
vehicle:
○
Push lock on the interior power door lock switch
with the driver and/or passenger door open.
○
Push the lock button on the exterior Passive
Entry door handle with a valid key fob available in
the same exterior zone
page 21.
○
Push the lock button on the key fob.
3. If any doors are open, close them.
TO DISARM THE SYSTEM
The Vehicle Security system can be disarmed using any
of the following methods:
•
Push the unlock button on the key fob.
•
Grab the Passive Entry door handle to unlock the
door
page 21.
•
Push the START/STOP ignition button (requires at
least one valid key fob in the vehicle).
18 GETTING TO KNOW YOUR VEHICLE
5548538-23_LA_OM_EN_USC_t_E2.pdf 18 4/7/2023 2:38:35 PM
To Next Page
Loading...
