PROGRAMMING THE MEMORY
FEATURE
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase the selected
profile from memory.
1. Place the vehicle’s ignition in the ON/RUN position
(do not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (i.e., seat, side mirror, power tilt and tele-
scopic steering column [if equipped], and radio sta-
tion presets).
3. Push and release the set (S) button on the memory
switch, and then push the desired memory button
(1 or 2) within five seconds. The instrument cluster
display will display which memory position has been
set.
NOTE:
Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
LINKING AND UNLINKING THE KEY
FOB TO MEMORY
Your key fobs can be programmed to recall one of two
saved memory profiles.
NOTE:
Before programming your key fobs you must select the
“Personal Settings Linked To Key Fob” feature through
the Uconnect system
page 95.
To program your key fobs, perform the following:
1. Place the vehicle’s ignition in the OFF position.
2. Select a desired memory profile, 1 or 2.
3. Once the profile has been recalled, push and
release the set (S) button on the memory switch.
4. Within five seconds, push and release button (1) or
(2) accordingly. “Memory Profile Set” (1 or 2) will
display in the instrument cluster.
5. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fob can be unlinked from your memory set-
tings by pushing the set (S) button, followed by pushing
the unlock button on the key fob within 10 seconds.
MEMORY POSITION RECALL
NOTE:
If a recall is attempted when the vehicle is not in PARK,
a message will be displayed in the instrument cluster
display.
To recall the memory settings for driver one or two,
push the desired memory button number (1 or 2) or the
unlock button on the key fob linked to the desired
memory position.
A recall can be canceled by pushing any of the memory
buttons (S, 1, or 2) during a recall. When a recall is can-
celed, the driver seat will stop moving. A delay of one
second will occur before another recall can be selected.
NOTE:
If the vehicle is equipped with Passive Entry, the
memory settings are recalled when using Passive Entry
to unlock the driver's door with a linked key fob.
SEATS
Seats are a part of the Occupant Restraint system of
the vehicle.
WARNING!
•
It is dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people riding in
these areas are more likely to be seriously injured
or killed.
•
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts. In a collision, people riding in these areas
are more likely to be seriously injured or killed.
•
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
MANUAL ADJUSTMENT (FRONT
SEATS) — IF EQUIPPED
WARNING!
•
Adjusting a seat while the vehicle is moving is dan-
gerous. The sudden movement of the seat could
cause you to lose control. The seat belt might not
be adjusted properly and you could be injured.
Adjust the seat only while the vehicle is parked.
•
Do not ride with the seatback reclined so that the
shoulder belt is no longer resting against your
chest. In a collision you could slide under the seat
belt and be seriously or even fatally injured. Use
the recliner only when the vehicle is parked.
26 GETTING TO KNOW YOUR VEHICLE
5548538-23_LA_OM_EN_USC_t_E2.pdf 26 4/7/2023 2:38:35 PM
To Next Page
Loading...
